Assembly Instructions
1. Open the package.
2. Check the edges and corners of each piece of glass to see if there are any defects or cracks. If yes, please contact the seller.
3. Tear the protective film on the plexiglass.
4. Understanding cabinets
5. According to the fourth approved quantity is consistent with the configuration.
Installation environment: requires a flat ground, conditonal, you can spread a layer of foam in the ground.
Installation Steps:
Take a partition and place it vertically with the side panel. Insert the buckle of the partition plate into the slot in the side panel as shown below(A).
Repeat the first step until all the partitions are inserted into the slot in the side panel, as shown below(B).
A
B
The slot on the rear vertical plate is aligned with the rear buckle of the side plate, and the rear vertical plate is pushed in the direction of an arrow to ensure that the rear plate board slot enters the buckle. (C) Before installing the door, take a door, a door shaft inserted into the side of the hole, the door of the other on the other side of the door shaft hole should be below, repeat steps C, install all the front door. Following chart(D).
C
D
Matters Needing Attention:
1. Handle with care and handle gently
2. The starting point should be B) carrying on the two lateral plates, not caught on the vertical plate, to prevent falling apart.
3. Do not hold the door plate or lift the spacer plate to prevent accidental damage to the glass when handling.